•Place a compression nut and ferrule over the spout tube.
•Install the mounting angle. Tighten the compression nut by hand, then finish tightening with a wrench.
•Screw the hot and cold connection hoses to the mounting angle.
•Place a compression nut and washer over the shank end of one of the connection hoses.
•Attach the hose to the outlet port on the valve with the compression fitting. Tighten with a wrench. Repeat with the other connection hose.
•Install the supply hoses (not included) and connect them to the stops.
•After the drain is installed, turn on the water and check all connections for leaks.
