What is the frequency label for the Azden 200R receiver?

The frequency label indicates the frequency in MHz the receiver operates on, and the Azden transmitter must be on the same frequency for proper operation.

How do I adjust the output on the Azden 200R receiver?

You can rotate the output adjustment knob clockwise to increase volume, or counter-clockwise to decrease volume.

What is the 12-volt input for on the Azden 200R receiver?

The 12-volt input is used to connect the supplied AC adaptor to the receiver, which should then be plugged into a 110-120 VAC electrical outlet.

200R Single channel VHF receiver | Azden 31XT, 211R, 311DRH 311, 31IT, DR 221R

(6) Frequency label

Indicates what frequency (in MHz) the receiver operates on. The AZDEN transmitter in use must also be on the same frequency.

200R Single channel VHF receiver:

The 200R features a 1/4-inch output jack and volume adjustment.

(1) Power/Receiving LED

When the receiver is plugged in, and the Power button is press IN, the Receiving LED will turn RED. When the transmitter is turned on and is in reception range of the receiver the Power/Receiving LED will turn from RED to GREEN indicating that the transmitter signal is being received. Press the Power button OUT to turn the 200R off.

(2) Antenna

Extend the antenna fully vertical for the best reception. When not in use, lower the antenna to avoid damage.

(3) 12-Volt Input

Plug the supplied AC adaptor into the 12-volt input on the receiver and then into a 110-120 VAC electrical outlet. Use only the adaptor supplied (BC-26U) as other adaptors may damage the receiver.

(4) Output Adjustment

Rotate this knob clockwise to increase, or counter-clockwise to decrease volume level.

(5) Output (unbalanced)

Using a suitable audio cable (not supplied) connect a 1/4-inch phone jack end to the audio output on the receiver and connect the other end of the cable to the mic/line input of an audio mixer or amplifier.