Manual Documentation Number: ZP24D-250RM-SR-2508 37
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Returned
Value
(Hex)
Association Indication
0x00 Successful Completion - Coordinator successfully started or End Device association
complete
0x01 Active Scan Timeout
0x02 Active Scan found no PANs
0x03 Active Scan found PAN, but the Coordinator Allow Association bit is not set
0x04
A
ctive Scan found PAN, but Coordinator and End Device are not configured to support
beacons
0x05
A
ctive Scan found PAN, but Coordinator ID (PAN ID) value does not match the ID of the End
Device
0x06
A
ctive Scan found PAN, but Coordinator CH (Channel) value does not match the CH of the
End Device
0x07 Energy Scan Timeout
0x08 Coordinator start request failed
0x09 Coordinator could not start due to Invalid Parameter
0x0A Coordinator Realignment is in progress
0x0B Association Request not sent
0x0C Association Request timed out - no reply was received
0x0D Association Request had an Invalid Parameter
0x0E Association Request Channel Access Failure - Request was not transmitted - CCA failure
0x0F Remote Coordinator did not send an ACK after Association Request was sent
0x10 Remote Coordinator did not reply to the Association Request, but an ACK was received _
after sending the request
0x11 [reserved]
0x12 Sync-Loss - Lost synchronization with a Beaconing Coordinator
0x13 Disassociated - No longer associated to Coordinator
AP (API Enable) Command
<Serial Interfacing> The AP command is
used to
enable the RF module to operate using a
framebased
API instead of using the default
Transparent
(UART) mode.
Refer to the API Operation section when API operation is enabled
(AP = 1 or 2).
AT Command: ATAP
Parameter Range:0 - 2
Parameter Configuration
0 Disabled (Transparent
operation)
1 API enabled
2 API enabled (with
escaped characters)
Default Parameter Value:0
Minimum Firmware Version Required:
v1.x80