ZONE CONFIGURATION
Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID c odes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.
Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. T his is very useful if you are
using speakers that can’t handle the maximum power output from your A/V System Controller or if you simply wish
to limit the volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the A/V System Controller may appear broken (no sound).
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
MENU
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
move to new line
previous page
↑ ↓
MENU select menu pageSEL
3 Control Out
4 Security Options
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter
←→
set desired maximum levelVOLUME KNOB
(REW) or(FF)
4
move to Z1 Max Level
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
3
activate ADVANCED ZONE SETTINGS
↵ (ENTER)
SEL or ENTER2
move to Zone Configuration
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
40 p/n 12698 Rev. 9808B