ALocate the seat pad and place it upside down on a firm surface.
BUnbuckle the straps on each side of the seat pad.
CUnfasten the
Hook-and-loop strap
D Hold the seat pad above |
the seat frame. Turn the |
seat pad so that opening |
for the vibration unit is |
at the front of the frame |
(footrest). |
Straps with buckles
Fabric flaps
Fabric pocket in seat pad
5
Install the batteries in the vibration unit.
The vibration unit requires (3) size C (1.5V) batteries (not included). Please use alkaline batteries for better performance.
CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture.
•Always keep batteries away from children. • Do not mix old and new batteries. • Do not mix alkaline, standard or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used. • Install the batteries so that the polarity of each one matches the markings in the battery compartment. • Do not
E | Open the pocket at the |
| top edge of the seat pad |
| and slide it over the |
| backrest frame. |
F | Lift up the two fabric |
| flaps (shown below). |
| Slide the two flaps over |
| and under the footrest |
| wire. |
Opening in seat pad
AUse a Phillips screwdriver to loosen the screw that secures the battery compartment cover. A retentive washer keeps the screw from falling off the cover.
BTemporarily remove the cover by disengaging the
2 tabs at the side opposite the screw.
CInstall the batteries...
•(If you are replacing batteries, remove the old ones first.)
Phillips screwdriver
Battery
cover
Vibration unit
Fabric flaps lifted
Fabric flaps under footrest wire frame
•Install (3) size C (1.5 V)
batteries, observing the polarity markings embossed on the bottom of the compartment.
•Install each battery by first tilting it so that the negative
G Gently tilt the bouncer | Straps fastened | |
backward until the | ||
| ||
backrest contacts the floor. |
|
H Fasten (buckle) the straps together on each side, securing the seat pad to the frame.
NOTE: Do not fasten the
CorrectIncorrect
DReplace the battery cover and tighten the screw. Do not overtighten.
– 3 –