Baby Trend 9178TW manual Parts, To Assemble Jogging Stroller

PARTS

	Front Wheel		Fender
			Fender Screws
Stroller	Parent Tray	Rear Wheels	Parent Tray Screws

TO ENSURE SAFE OPERATION OFYOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

TO ASSEMBLE JOGGING STROLLER

•Remove stroller from box. The front wheel, rear wheels, fender, and parent tray need to be installed prior to use.

•To attach the front wheel, unfold stroller as described in the section following. See figure 1.

Lean the stroller backwards so that it rests on the handle and rear axle frame and the front wheel forks are pointing upward.

The front wheel features a quick release attachment system. See figure 3. Slide the front wheel onto the front forks. See figure 2. The quick release must be loose enough for the wheel to slide on and the brake release lever must be in the open position (see figure 6). Line up the tab on the Holding Plate with the slot on the fork plate. With the wheel in position, tighten the finger nut on the axle until it is very close to contacting the fork. See figure 4. Rotate the lever to the closed position as shown in figure 5. You should feel significant resistance when closing the lever and the wheel should be held tightly. If you do not, open the lever and tighten the finger nut a bit more and close the lever again. Continue to do this until the wheel is held tightly in the fork.

Close the brake release lever by rotating it toward the front of the stroller. See figure 6.

Figure 1.

Figure 2.

		Ring
	Open	Close
Figure 4.	Figure 5.	Figure 3.
		3