Baja Marine 250 manual Basic Boat Dimensions and Clearances Metric, Propulsion System

Section 2 • General Boat Arrangement

Basic Boat Dimensions and Clearances (Metric)

Boat Dimensions and Clearances

(Fig. 2.3.1)

8.13m

7.62m

2.82m

1.80m

1.70m

250 Sportfish Specifications Height Dimensions

Overall Length	7.59 m
Overal Length w/ Drive down	8.76 m
Beam (width)	2.59m
Draft (stern drive down)	91.44 m
Draft (stern drive up in trailering position)	78.74 cm
Dry Weight (single)	1, 769 kg
Dry Weight (twin)	1, 950 kg
Fuel Capacity	529.9 liters

4.Propulsion System

Your boat is equipped with a stern drive type propulsion system also known as an inboard- outboard engine. (See Figure 2.2.2) This type of propulsion system has the engine inside the boat secured to the hull's stringers at the rear end of the hull. The stern drive unit, also called the lower unit because it hangs below the hull, is part of the propulsion system that attaches to the outside of the hull or transom. The stern drive unit pivots to steer the boat.

For engine operating instructions, see page 3.4.

From Keel
without Windshield	1.88 m
Keel To Top
Of Windshield	2.22 m
From Waterline
to Top of Windshield	1.19 m
From Waterline to Top
of Windshield	1.30 m
From Keel to Top
of Arch/Tower	2.82 m

5.Propellers

Your Baja® has been equipped with a propeller which our tests have shown to be the best suited for general use under normal conditions and load.

Under no circumstances use a propeller which allows the engine to operate at higher than the maximum RPM for your engine. (See the Engine Operator's Manual.)

250 Sportfish® 2.3