4 | Set up the loudspeaker |
We recommend that you follow this procedure:
–Disconnect your system from the mains supply.
–Place the loudspeakers in your setup.
–Set the switches to the correct setting. This is explained in ‘Adapt the loudspeakers to your setup’ (page 6).
–Connect your speaker system.
–Connect the entire system to the mains again.
If you mount the loudspeaker on a wall bracket, you cannot assemble the base to the loudspeaker.
NOTE! The type number of the loudspeaker appears on the label which is placed on the inside of the socket panel cover.
Cautions
–Make sure that the loudspeakers are placed and connected in accordance with the instructions in this Guide. To prevent injury, use Bang & Olufsen approved stands and wall brackets only!
–The loudspeakers can only be switched off completely by disconnecting them from the wall socket.
–The loudspeakers are designed for indoor use in dry, domestic environments only, and for use within a temperature range of
–Remember that all speakers in a setup must be connected to a mains outlet, and that they are designed to be connected to the mains at all times, as this allows them to switch on automatically.
–Do not attempt to open the loud speaker. Leave such operations to qualified service personnel!
Column and base
It is easiest to assemble the base and the speaker column if the loud speaker is placed on the two foam packaging blocks – as shown.
Remove the small plastic cylinder from the threaded end of the loud speaker, and push the base onto the threaded end. Fasten the base to the column with the washer and nut. Tighten the nut carefully.
