Fiber Installation Instructions
Banner Engineering Corp. 9714 Tenth Ave. No., Minneapolis, MN 55441 Telephone: (763) 544-3164 FAX: (763) 544-3213
D12 Series sensors for
use with plastic fiber optic
assemblies include sensors
with the letters FP in their
model number suffix.
Install the plastic fiber optic assembly(s)
as follows:
1) Prepare the sensor ends of the fibers
(see page 1, bottom).
2) Unlock (slide up) the fiber gripper.
3) Gently insert the prepared plastic fiber
sensor ends into the ports as far as they
will go. Slide the fiber gripper down to
lock.

D12 Series

OMNI-BEAM, MAXI-
BEAM, VALU-BEAM,
and Q45 Series sensors for
use with plastic fiber optic
assemblies include sensors
with the letters FP in their
model number suffix.

OMNI-BEAM, MAXI-BEAM, VALU-BEAM,

Q45 Series

Install the plastic fiber optic assembly(s)
as follows:
Prepare the sensor ends of the fibers
(see page 1, bottom).
Loosen the clamp screw on the sensor
face.
Follow steps 1-3 in the drawing, right.

MINI-BEAM, ECONO-BEAM

Install the plastic fiber optic
assembly(s) as follows:
Prepare the sensor ends of the
fibers (see page 1, bottom).
Loosen the clamp screw on the
sensor face.
Follow steps 1-3 in the
drawing, right.
MINI-BEAM and ECONO-
BEAM sensors for use with
plastic fiber optic assem-
blies include sensors with
the letters FP in their model
number suffix.
Q19 Series sensors for
use with plastic fiber optic
assemblies include sensors
with the letters FP in their
model number suffix.
Install the plastic fiber optic assembly(s)
as follows:
1) Prepare the sensor ends of the fibers
(see page 1, bottom).
2) Unlock (slide up) the fiber gripper.
3) Gently insert the prepared plastic fiber
sensor ends into the ports as far as they
will go. Slide the fiber gripper down to
lock.

Q19 Series

PC44 Series sensors for
use with plastic fiber optic
assemblies include sensors
with the letters FP in their
model number suffix.
Install the plastic fiber optic assembly(s)
as follows:
1) Prepare the sensor ends of the fibers
(see page 1, bottom).
2) Raise (liftup) the fiber gripper door.
3) Gently insert the prepared plastic fiber
sensor ends into the ports as far as they
will go. Lower the fiber gripper to
lock.

PC44 Series