
4. Connections
How to select the new installed module?
Thenew installed module can be selected with the digit buttons on the RCU or the local keypad.
4.5.4 Fixed slot (slot 1 & 2)
Where to find?
Slot1 & 2 has 5 BNC input terminals for 5 cable input and a DVI plug for DVI input. Slot1 has also an DVI output for loop through
toa second projector. Withinthe installation mode it is possible to setup the input for 5 cable or DVI (PanelLink).
Which signals can be connected to slot 1 & 2?
Connector name/
Input signal
RGB H V
RGBHV RGB H V
RGBS RGBS-
RGsB RGs B- -
Composite Video -Video - - -
Super Video -Y- - C
ComponentVideo — SS R-Y YB-Y S-
ComponentVideo — SOY R-Y Ys B-Y - -
DVI signals can be connected to the DVI input connector.
Pin assignment for the DVI connector.
Pin 1 TMDS DATA2- Pin13 TMDSDATA3+
Pin 2 TMDS DATA2+ Pin14 +5Power
Pin 3 TMDSDATA2/4 Shield Pin15 Ground(for +5V)
Pin 4 TMDS DATA4- Pin 16 HotPlug Detect
Pin 5 TMDS DATA4+ Pin17 TMDS DATA0-
Pin 6 DDC Clock Pin18 TMD S DATA0+
Pin 7 DDC Data Pin 19 TMDS DATA0/5Shield
Pin 8 No connect Pin20 TMDS DATA5-
Pin 9 TMDS DATA1- Pin21 TMD S DATA5+
Pin10 TMDS D ATA1+ Pin22 TMDS Clock Shield
Pin11 TMDS DATA1/3Shield Pin23 TMDS Clock+
Pin12 TMDS D ATA3- Pin24 TMDS Clock-
How to select input slot 1 or 2 ?
1. Key in 1 or 2 on the RCU or the local keypad.
How to change the input slot setting?
1. Press ADJUST or ENTER key to start up the Adjustment mode.
2. Push the cursorkey ↑or↓to select Installation. (menu 4-4)
3. Press ENTER.
4. Press the cursor key ↑or ↓to select In put Slots. (menu 4-5)
R5976801 SLM R9+ 20/10/2004 35