9. Service Mode
The following items will be displayed:
• Typeof projector: SLM R12+
• Software version
• Network module: yes
• Proj. address: To change the address of the projector, see "Change Projector Address", page 114
Installation:
- front/ceiling
- front/table
- rear/ceiling
- rear/table
• Baudrate: transferspeed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be
thesame as the baud rate of the connected computer. When there is a difference, consult ’Change Baudrate PC’ in this chapter.
• ProjectorRun Time: givesthe total run time since the first start up. Allprojectors leave the factory with a run time of approxi-
mately 24 hours.
• ProjectorSerial number: indicatesthe fabrication number of the projector. This number can be useful when calling for technical
assistance.
Start Up
1. Push the cursor key ↑or ↓to highlight Iden tification.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑or ↓
then <ENTER>
<EXIT> to return
Menu9-4
2. Press ENTER to display the Identification screen.
SLM R12+
Proj. address: 001
Soft. version: 3.0
Config: front/ceiling
Bautrate PC: 9600
Network module: yes
Text: on
Serial No:1010200
Run time: 100 h
Select with ↑or ↓
then <ENTER>
<EXIT> to return.
Menu9-5
9.4 Password
Overview
• Change Password
• Access Control List
9.4.1 Change Password
How to enable or disable the password function?
This item isp assword protected when the password strap is installed.
Thepassword function is enabled when the password strap ,s econd switch ofS2 on the controller mod uleis installed. Consultan
authorized Barco service technician to change the strap position.
About password types.
3 differentpassword levels are built in, in the projector software.
110 R5976654 SLM R12+ 27/01/2005