4. Connections
Lamp run time indication while running
Whenthe total run time of the lamp is 30 h ours less then 1000, the following warning message will be displayed for 1 minute. This
warningmessage will be repeated every 30 m inutes. Press EXIT to remove the message before the minute is over.
Remaining
Lamp run time
20h
Image4-2
Whenthe total run time of the lamp is 1000 hours ormore, the following warning message, withthe exact run time is displayed on
the screen.
WARNING
Lamp run time is x hours
operating the lamp longer
than x hours may damage
the projector.
Please replace the lamp
<ENTER> to continue
Menu4-1
Lamprun time is 1000 ho urs. Operating the lamp longer than maximum runtime hours may damage the projector. Please replace
the lamp.
When ENTER is pressed to go on, the warning willbe repeate de very30 min.
Thetotal lifetime of the lamp for a safe operation is 1000 hours max. Donot use it longer. Alwaysreplace with a same type of lamp.
Calla BARC O authorizedservice technician for lamp replacement.
CAUTION:Usinga lam p for more than 1000 hours is dangerous as the lamp could explode.
Lamp Light Output Indication
When starting up and the center lumens measurement is lower than 50 % of its initial value, the lamp light output warning will be
displayed. Press ENTER to continue. The message will not be repeated during operation.
WARNING
Lamp run time is X hours
The light output of the lamp
is less
than 50% of its initial value.
It is advisable to replace the
lamp
before damage occurs.
<ENTER> to confirm
Menu4-2
Whenthe ’Constant Light Output’ (CLO) options is installed, the light output message will appear on the screen whenthe light output
is reduced with 33% from its initial value.
This message will be repeated everyh our.
Lamp Z-axis indication
Whenstarting up and the run time is 100 hours or 250 hours a Z-axis warning will be displayed. Thiswarning will advise to adjust the
Z-axisof the lamp to obtain maximum light output. Press ENTER to continue. The message will not be repeated during operation.
WARNING
Lamp run time is X hours.
It is advisable to
adjust the Z-axis
of the lamp to
obtain maximum
light output
(see owner’s manual)
<ENTER> to confirm
Menu4-3
34 R5976654 SLM R12+ 27/01/2005