IMPORTANT: Position front lip of economizer under front grille and on top of condenser partition. (See Figure 3 inset.) This is important to ensure proper drainage of any water entering damper assembly.
6.Mount mixed air thermistor to blower partition as shown with screws provided. Bracket with sensor installs on top of blower partition. Screws are inserted from the underside. Route wires as shown and secure with wire tie. Connect wires to thermistor. (See Figures 2 & 3.)
7.Open unit control panel to gain access to unit low voltage terminal block.
8.FOR LEFT HAND UNITS Reroute economizer wiring harness to the left side. (See Figure 4.)
9.Route electrical harness leads through the 7/8" bushing in control panel (Figure 5) into low voltage box.
FIGURE 4
Manual | |
Page | 7 of 13 |
