Bassworx BA1200.1D, BA800.1D, BA75.2, BA150.2, BA75.4, BA500.1D, BA150.1 manual Speaker Connections

Speaker Connections

This amplifier can operate in either one, two or three channel mode. The minimum impedance for single channel (bridged/mono) operation is 4-8 ohms. There channel tri-power is referred to stereo and mono at the same time. Minimum impedance remain the same for three channel (satellite/ subwoofer) systems as long as proper passive crossovers are used.

Connect right and left speaker wire to corresponding speaker output terminals of the amplifier.

Be sure to have the positive wire from the speaker to the positive speaker terminal of the amplifier and the negative wire from the speaker must connect with the negative speaker terminal of the amplifier. Reversing any of these connections will result in the speaker cones moving out of phase which causes bass cancellation. See Fig.3 Speaker Output Connections.

1 CHANNEL SPEAKER WIRING DIAGRAM

1 SPEAKER BRIDGED

FUSE +12VDC REM GND

SPEAKER POWER

1 CH

2-8 Ohms

Fig.3

9