OWNER GUIDE
changing the burner setting. ·The burner settings are;
Control Knob | Burner appearance | |
Position | ||
| ||
|
| |
1 / IGN | Centre section on low. Outer sections off. | |
|
| |
2 | Centre section fully on. Outer sections off. | |
|
| |
3 | Centre section fully on. Outer sections on low. | |
|
| |
4 | All sections fully on. | |
|
|
·We recommend that the fire is set at position 4 for the first 10 minutes after lighting to warm up the chimney and so obtain full efficiency quickly.
·If operating the appliance for long periods it is beneficial occasionally to change the settings. This will also help to remove any carbon deposits that may form during operation.
Note: If the fire goes out while setting the control, repeat the full lighting procedure. If the fire repeatedly goes out, have the fire serviced.
To turn the fire off.
·Partially depress the control knob and turn clockwise to OFF. Release the knob.
·Wait at least 3 minutes after turning the fire off before relighting.
Lighting with a taper.
In the unlikely event of failure of the ignition spark, the pilot can be lit with a taper or long spill after the window surround has been
removed. Removal of the surround is described in the "Window Glass" chapter on the next page.
Light the pilot by inserting the taper or spill below the centre of the window while the control is kept depressed at the 1/IGN position (See figure 3).
When the pilot has lit follow the rest of the instructions in the section headed "To light the fire". Always replace the window unit after
lighting.
Figure 3.
© Baxi Heating U.K. Limited 2007. | Page 8 |
