MOUNTING THE CS8A5
Figure 1 
Top Bottom
1.With the topside of the buckle facing up (see figure 1), lace the strap through the mounting base as illustrated in figure2.
Figure 2
Figure 4
3.Place each mounting base under the CS8A5 so that the apex at the bottom of the tube sits inside the mounting base as in figure 4.
Figure 3
2.After the strap is completely laced through the mounting base, make a loop with the strap, where it runs across the middle of
the base as illustrated in figure 3. This loop is necessary to access the two mounting holes in the base.
,, | Figure 5 | ,, |
3 |
| 3 |
4.Move the bases so that they are spaced approximately 3” from each end of the enclosure as illustrated in figure 5.
5.Remove the CS8A5 without moving the mounting bases and set it aside.
6.Screw each mounting base securely in place with screws provided as illustrated in figure 3.
7 | 8 |
