FRONT PANEL

LOW

 

 

PROCESS

 

 

1/4” INPUT

CONTOUR

 

 

CONNECTOR*

CONTROL

 

 

CONTROL

IN/OUT TOGGLE The 1/4” input connector of the

Regulates the

 

 

 

SWITCH

DI-1000 is unbalanced. The 1/4”

Regulates the amount amount of phase

input is designed for running

of phase corrected

correction.

Engages the Sonic

instrument cables directly

bass frequencies.

Maximizer Process.

 

 

 

 

into the DI-1000.

ACTIVE/

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PASSIVE

 

 

 

 

 

 

 

 

 

 

SWITCH

 

 

 

 

 

 

 

 

 

 

In the Passive posi-

 

 

 

 

 

 

 

 

 

tion, the instru-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ments

signal is

 

 

 

 

 

 

 

 

 

routed

straight

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

from the input to

 

 

 

 

 

 

 

 

 

the Jensen

trans-

 

 

 

 

 

 

 

 

 

former

and

then

 

 

 

 

 

 

 

 

 

directly to the XLR

 

 

 

 

 

 

 

 

 

output. This is a strictly passive, impedance-match only mode. In

PAD SWITCH

this mode, the Sonic Maximizer function is not available.

The Pad switch is used to select the

 

 

 

 

 

 

 

In the Active position, the instruments signal is fed to a Buffer Amp

desired gain range of the DI-1000.

with an input impedance of 1Meg Ohm. In this mode the Sonic

When switched to –30dB the DI-

Maximizer function is available. The signal is then routed to the

1000 will accept the speaker-level

Jensen transformer balanced XLR output.

 

 

output of your instrument amplifier.

1/4” THRU CONNECTOR*

This 1/4 “ connector is wired in parallel to the Input connector and is used for continuing the connection to the instrument amplifier.

*WARNING

When connecting the speaker level output of a tube amplifier to the input of the DI-1000, a speaker load (cabinet) must be connected to the Thru Connector or damage to your tube amplifier will occur.

5