USERS GUIDE
10PBJSx SERIES PUSHPLATE
DESCRIPTION | This pushplate series (10PBJSx) is designed to fit neatly into standard |
| |
| directly to a door jamb. The faceplates are made of 1/16” thick stainless steel for durable use. |
|
|
INSTALLATION INSTRUCTIONS
1.Determine the mounting location of the pushplate. Use the enclosed mounting template if the pushplate is to be attached directly to the door jamb, otherwise, the pushplate will mount directly into a
2.If the pushplate is to be mounted directly to the jamb tube, use the template and mark the drill locations by tapping the holes with a hammer and center punch. Then proceed to drill the holes and cut out the recess for the switch.
3.Wire the switch of the pushplates to the door controllers using the normally open contact and common.
4.Fasten the pushplate to the mounting location.
5.Test the pushplate for proper activation.
| 10PBJS1 | 10PBJS1 WITH 3 ¼” |
| HOLE SPACING BOX | |
|
| |
|
| (by others) |
|
| |
PUSHPLATE | The pushplates are constructed with durable stainless steel and painted with | |
CLEANING | the plates, use only a damp, |
may cause deterioration of the coating. Please make the
COMPANY CONTACT
If after troubleshooting a problem, a satisfactory solution cannot be achieved, please call B.E.A., Inc. for further assistance during Eastern Standard Time at
For
West Coast:
NEVER sacrifice the safe operation of the automatic door or gate for an incomplete solution. Web: www.beasensors.com
75.5093 V1 Aug 2003 [Rev. July 19, 2006] | Page 1 of 1 |