Service And Maintenance
This appliance should be checked and serviced by an authorised service person every 2 years to ensure the appliance remains in a safe operating condition. (These services are not covered by warranty). Replacement parts are available from your authorised BeefEater Dealer
Each use | Every 6 | By authorised service |
| months | agent every 2 years |
Check all hoses for cracks and leaks
Check that all gas connections are tight
Clean entire barbecue thoroughly
Check and tighten all bolts on barbecue and trolley
Clean and inspect Vaporizers
Clean and inspect barbecue burners
Clean and inspect gas injectors and control valves
Check working of ignition system
Trouble Shooting Guide
Problem | Cause | Check |
Barbecue will not light | Ignition system not working | Check to see visible spark at starter probe - if no |
|
| spark is present when control knob is turned then |
|
| the unit may need to be serviced or replaced. |
|
| Contact your BeefEater dealer. |
|
| Check that there is a visible flame coming from |
|
| the pilot ignition tube. |
|
| Check that the pilot ignition tube is not blocked by |
|
| spider webs or insect nests. |
| Turning on gas control too | Allow at least 5 seconds for gas to flow through |
| quickly | burner before ignition |
| No gas flow | Check that valve on gas cylinder is turned on. |
|
| Check that burner ports are free of obstructions |
|
| Check that all gas injectors are clean and free of |
|
| obstructions |
| Burners not assembled | Check that burners are correctly positioned in the |
| correctly | barbecue frame. |
| Burner ports or throat | Check that the burner ports are not blocked by |
| blocked | spider webs or insect nests. Clean out as required |
Barbecue lights but goes | Fuel supply turned off | Turn on gas valve at cylinder |
out soon after starting |
|
|
Burners will not cross light from one to the other
Low flame level or low heat output
Gas cylinder low or empty | Refill cylinder with gas |
Kink in gas hose | Check that the gas line is not kinked or twisted |
Wind or breeze affecting | Ensure that the appliance is located out of the |
operation | way of wind |
| Check that cross light channel is in place |
| Check that burner ports are free of obstructions. |
| Check you are running on correct gas |
| Check gas injector size is correct |
12
