XENYX 1002B User Manual

3. Controls and Connectors

3.1 Front Panel

5

ENGLISH

[1]MIC – Plug a microphone into this input using an XLR cable.

[2]LINE IN – Plug a line-level source into this jack using a ¼" TS or TRS cable.

[3]INS(ERT) – Plug an external dynamic processor into this jack using a TRS to dual TS cable. You may also use the INSERT jack as a pre-EQ/pre-fader send by plugging in a

¼" TS cable part way to the first click.

[4]STEREO LINE IN – Plug in a stereo source using two ¼" TS cables, or a single line-level source using the left input jack only.

[5]GAIN LINE – Adjusts STEREO LINE IN sensitivity, also known as “gain setting.”

[6]GAIN MIC – Adjusts MIC input sensitivity, also known as “gain setting.”

[7]CLIP – Lights when preamp begins to overload.

[8]PAN/BAL – Adjusts the left-to-right positioning of the

channel in the stereo field.

[9]HIGH – Adjusts frequencies above 10 kHz by +- 15 dB.

[10]MID – Adjusts frequencies peaking at 700 Hz by +- 15 dB.

[11]LOW – Adjusts frequencies below 50 Hz by +- 15 dB.

[12]MON – Adjusts the amount of signal sent to the MON SEND jack. This signal is sent pre-fader.

[13]FX – Adjusts the amount of signal sent to the FX SEND jack. This signal is sent post-fader.

[14]CHANNEL FADER – Adjusts the channel volume in the main mix.

[15]2-TRACK OUTPUT – Connect to the inputs of recording device using RCA cables.

[16]2-TRACK INPUT – Connect to outputs of CD, tape or MP3 player using RCA or ¼" cables.

[17]PHONES – Connect a pair of headphones with a ¼" TRS plug.