ENGLISH

16

wired in a balanced configuration. In case of doubt, contact the microphone manufacturer!

Connect microphones before you switch on the phantom power supply. Please do not connect microphones to the mixer (or the stagebox/wallbox) while the phantom power supply is switched on. In addition, the monitor/PA loud-speakers should be muted before you activate the phantom power supply. After switching on, wait approx. one minute to allow for system stabilization.

Caution! Please also note the information given in chapter 6.2.1“Audio connections”.

SERIAL NUMBERPlease note the important information on the serial number given in chapter 1.3.3.

6. INSTALLATION

6.1 Rack mounting

The packaging of your mixing console contains two 19" rack mounts for installation on the side panels of the console.

Before you can attach the rack mounts to the mixing console, you need to remove the screws holding the left and right side panels. Then, use these screws to fasten the two rack mounts, each specifically to one side. With the rack mounts installed, you can mount the mixing console in a commercially available 19" rack. Be sure to allow for proper air flow around the unit, and do not place the mixing console close to radiators or power amps, so as to avoid overheating.

Only use the screws holding the mixing console side panels to fasten the 19" rack mounts.

XENYX 1622FX/1832FX/2222FX/2442FX User Manual

6.2 Cable connections

You will need a large number of cables for the various connections of the console. The illustrations below show the wiring of these cables. Be sure to use only high-grade cables.

strain relief clamp sleevetipsleevepole 1/ground

tip

pole 2

The footswitch connects both poles momentarily

1/4" TS footswitch connectorFig. 6.1: Foot switch connector
6.2.1 Audio connections
Please use commercial RCA cables to wire the 2-track inputs and outputs.

You can, of course, also connect unbalanced devices to the balanced input/outputs. Use either mono plugs, or use stereo plugs to link the ring and shaft (or pins 1 & 3 in the case of XLR connectors).

input

21

3

1 = ground/shield2 = hot (+ve)3 = cold (-ve)output

12

3

For unbalanced use, pin 1 and pin 3 have to be bridged

Balanced use with XLR connectorsFig. 6.2: XLR connections

XENYX 1622FX/1832FX/2222FX/2442FX User Manual

Caution! You must never use unbalanced XLR connectors (PIN 1 and 3 connected) at the MIC input jacks if you want to use the phantom power supply.

Strain relief clampSleeveTip

Sleeve

(ground/shield)

Tip

(signal)Unbalanced ¼" TS connectorFig. 6.3: 1/4” mono plugstrain relief clampsleeve ring tip

sleeve

ground/shieldringcold (-ve)

tip

hot (+ve)

For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug.

Balanced 1/4" TRS connectorFig. 6.4: ¼" stereo plug

strain relief clamp

sleeve ring tip

sleeve ground/shield

ring

return (in)

tip

send (out)

Connect the insert send with the input and the insert return with the output of the effects device.

Insert send return 1/4" TRS connectorFig. 6.5: Insert send/return stereo plug

strain relief clamp

sleeve ring tip

sleeve ground/shield

ring

right signal

tip

left signal1/4" TRS headphones connectorFig. 6.6: Stereo plug for headphones connection

17

ENGLISH