iAXE
2. Installation for Windows
2.1 Installing the iAXE
To install the USB AUDIO driver, proceed as follows:
1)Power on your computer.
2)Insert the CD into your CDROM drive.
3)Locate the folder "ASIO_driver" on the CD and open it.
4)
5)Follow the
6)Restart your computer after the installation has finished.
To properly configure the driver for audio applications, proceed as follows:
1)Start the
2)In the USB tab, make your choice according to the screen- shot.
Fig. 2.1:
3)In the ASIO tab, make your choice according to the screen- shot.
Fig. 2.2:
2.2 Installing the Guitar Combos software
The Guitar Combos software consists of three different combos. Choose any or all of them for installation. With the serial number on the CD sleeve you can fully activate one combo. For details, refer to the imprint on the CD sleeve. All other combos can be run in demo mode with the following restrictions:
== Saving of sounds is disabled
== Quits after 30 minutes == Total recall is disabled
To install a combo on your system, proceed as follows:
1)From the folder "NI Guitar Combos" on your CD, choose the combo you wish to install and open the respective archive file
(ZIP) by
2)
3)Follow the
If you have the serial number for the installed combo:
4)Accept to start the NI Service Center, by checking the respec- tive entry.
++ If your computer is not connected to the internet, choose the offline registration method to activate the combo via another computer.
5) Follow the
Fig. 2.3: Product activation with NI's Service Center
++ If you do not have the serial number for the installed combo, you can only run the combo in demo mode.
To setup the combo, proceed as follows:
1)Start the
2)In the Audio Setup window, make your choice according to the screenshot.
3)Please note, when using the Guitar Combos
Installation for Windows | 3 |