TRUTH B2030P/B2031P
3.1.1 The truth about speaker cables
Carefully approach the choice of what cables you use. Which cables you use can have a major influence on your sound. Cables of various lengths and diameters affect the resistance
On the other hand, that doesn’t mean that you should be buying
3.1.2 Amp
The power rating of the amp you use should be roughly twice the load capacity of your TRUTH. Consequently, the B2030P should be operated with an amp with a load capacity of 2 x 200 Watts, and the B2031P with an amp with a load capacity of 2 x 300 Watts.
Also, you should keep in mind the impedance of your TRUTH in order to guarantee optimal power delivery. The B2031P’s impedance is 4 Ω, whereas the B2030P’s is 8 Ω. Use an amp whose power rating roughly corresponds to the values recommended in the table. The impedance should correspond to the values listed in the table:
TRUTH | Amp power rating |
B2030P | 200 W into 8 Ohm |
|
|
B2031P | 300 W into 4 Ohm |
Tab. 3.1: Recommended amp power ratings
Of course, you can use amps with higher power ratings. However, make sure not to exceed the load capacity of your TRUTH. Damage to speaker components caused by exceeding their load capacity is not covered by the warranty.
3.1.3 Protecting your TRUTH
To ensure that your B2030P/B2031P last for years to come, you should definitely keep the following in mind:
sAlways turn the volume down on your amp before switching it on or off.
sWhen powering your equipment up/down, the amp should always be the last one to be powered up and the first one to be powered down. This way, you avoid loud crackling noise that occurs when you turn studio equipment on or off.
sAlways make sure your audio signal level is optimally set. Avoid overdriving your amp.
sDo not push your studio monitors beyond their physical limitations. Even though your TRUTH has sufficient power overhead, you can still damage it if you drive it too much or crank the volume all the way up for longer periods of time.
3.2 Speaker placement suggestions
Since the sound of a speaker depends to a great extent from its surroundings, placing your TRUTH correctly is very important. Please try to follow these suggestions through. Your efforts will be rewarded with better sound and higher resolution.
Both speakers are built identically. There is no need to concern yourself with which speaker should be placed left and which speaker should be placed right. Place the TRUTHs on a flat and stable surface, if possible use a dedicated speaker stand. In this way, the speaker is acoustically decoupled and won’t induce vibrations in nearby objects, which would affect the bass response. If you cannot use a stand, put the TRUTHs on spikes or damping foam material. Another aspect is the distance between speaker and wall: keep the speaker away from the wall, as this would emphasize the bass response, particularly in corners, where two walls form an angle.
The BEHRINGER TRUTH B2030P/B2031P is a
Fig. 3.2: Incorrect speaker setup
This illustration shows how you shouldn’t do it: you can clearly see that a portion of the sound bounces back from the walls before it reaches the listener’s ears. Thus, direct and reflected sound waves overlap which results in a coloration of the sound.
Fig. 3.3: Correct speaker setup
This effect can be reduced by turning the speakers towards the listener. To make reflections from ceiling or floor less likely, the tweeters should be on the same height as your ears. Please note that the TRUTH should be operated vertically. Where this is impossible, place it horizontally as shown in the illustration (i.e. woofers closer to each other), to allow for an improved stereo image.
Fig. 3.4: TRUTH setup horizontally
Not only the physical location of speakers but also the acoustic characteristics of the room have a substantial effect on the way your TRUTH sounds. Make sure that the room neither sounds too
6 | 3. APPLICATION |