Behringer BX3000T manual Wiring Examples, Rear panel

Models: BX3000T

1 11
Download 11 pages 41.33 Kb
Page 7
Image 7

ULTRABASS BX3000T

2.2 Rear panel

Fig. 2.4: BX3000T rear panel (section 1)

Use the POWER switch to switch the BX3000T on or off. You should always make sure that the POWER switch is in the “Off” position when initially connecting the unit to the mains.

To disconnect the unit from the mains, pull out the main cord plug. When installing the product, ensure that the plug is easily accessible. If mounting in a rack, ensure that the mains can be easily disconnected by a plug or by an all-pole disconnect switch on or near the rack.

+Please note: Merely switching the unit off does not mean that it is fully disconnected from the mains. When not using the unit for prolonged periods of time, please unplug the unit’s power cord from the power outlet.

MAINS CONNECTION. Use the power cord supplied with the unit to connect it to the mains.

FUSE HOLDER/VOLTAGE SELECTOR. Before connecting the unit to the mains, make sure that the voltage setting matches your local voltage. A blown fuse should only be replaced by a fuse of the same type and rating. On some units, the fuse holder can be switched to one of two positions, i.e. 230 V and 120 V. When operating the unit outside Europe at 120 V, a higher fuse rating is required.

SERIAL NUMBER. Please take the time to fill in and return the warranty card within 14 days after the date of purchase, so as to benefit from our extended warranty. Or register online at www.behringer.com.

Fig. 2.5: BX3000T rear panel (section 2)

Use the SPEAKER outputs to connect your loudspeakers. The outputs are wired in parallel on two 1/4" jacks and a SPEAKON® connector.

+Your speaker cabinets should have a sufficient

power rating (>300 W) and preferably a total impedance of 4 W to avoid speaker damage. Too high a load impedance will decrease the output power rating of the power stage!

+For correct speaker connection please also refer to chapters 3.3, 3.3.1 and 6.2.1!

3. WIRING EXAMPLES

This chapter is aimed at describing and illustrating basic wiring examples.

3.1Standard setup comprising footswitch and one loudspeaker

The standard setup is intended for rehearsals, sessions and club gigs.

Fig. 3.1: Standard setup

3.2Expanded setup with tuner and connection to a mixing console

The wiring scheme shown here builds on the standard setup.

Fig. 3.2: Expanded setup

The output signal of your BX3000T can be taken directly at the XLR D.I. output and fed to a microphone input of your mixing console using a balanced microphone cable. Please ensure that phantom power is switched off on the respective channel of your mixer!

3. WIRING EXAMPLES

7

Page 7
Image 7
Behringer BX3000T manual Wiring Examples, Rear panel, Standard setup comprising footswitch and one loudspeaker