Behringer DI4000 +

ULTRA-DI PRO DI4000

Your BEHRINGER ULTRA-DI PRO was carefully packed in the factory and the packaging was designed to

protect the unit from rough handling. Nevertheless, we recommend that you carefully examine the packaging

and its contents for any signs of physical damage, which may have occurred in transit.

+If the unit is damaged, please do not return it to us, but notify your dealer and the shipping

company immediately, otherwise claims for damage or replacement may not be granted.

Shipping claims must be made by the consignee.

The BEHRINGER ULTRA-DI PRO fits into one standard 19" rack unit of space. Please allow at least an

additional 4" (10 cm) depth for the connectors on the back panel.

+Be sure that there is enough space around the unit for cooling and please do not place the

ULTRA-DI PRO on high temperature devices such as power amplifiers etc. to avoid overheat-

ing.

The mains connection of the ULTRA-DI PRO is made by using the supplied cable. It meets all of the interna-

tional safety certification requirements. Please make sure that all units have a proper ground connection.

+Before you connect your ULTRA-DI PRO to the mains, please make sure that your local voltage

matches the voltage required by the unit!

The BEHRINGER ULTRA-DI PRO has four identical channels. The control elements are identical on all

channels.

Fig. 1.1: Control and display elements on the front panel

1OUTPUT. This is the balanced output of the ULTRA-DI PRO. The connection to the mixing desk should

be made with a standard high-quality balanced cable.

2+20 dB gain switch for pre-amplification of low level signals.

3Switchable HIGH CUT filters (8 kHz) for guitar applications (6 dB/Oct).

4With the PHASE REVERSE switch the input signal is reversed in phase by 180°.

5Use the GND LIFT switch to either connect the ground of input and output or keep them completely

separate. Depending on the grounding of the connected devices linking or disconnecting will reduce

hum or prevent ground loops. GROUND LIFT ON means no interconnection.

6The OUTPUT LEVEL meter displays the output level of the ULTRA-DI PRO in a range from -24dB to

+18dB.

7Use the POWER switch to turn on the BEHRINGER ULTRA-DI PRO.

1. INTRODUCTION