ENGLISH

12

9.2 Plug soldering guide

You will need a lot of cables for different purposes—see the following figures to make sure you have got the right ones.

Use custom-made RCA cables for all connections which use RCA sockets (centre post = signal (+ve) and sleeve = ground/screen).

Pro Mixer DX2000USB User Manual

Balanced use with XLR connectors

input

1 = Ground / Shield

2 = hot (+ve)

3 = cold (-ve)

output

For unbalanced use pin 1 and pin 3 have to be bridged

Fig. 10.1: Un-/balanced jack plugs and balanced XLR connectors

Pro Mixer DX2000USB User Manual

Fig. 10.3: Insert send/return plug

13

10.2 Slope

With the SLOPE potentiometer (VR44) you can adjust the fade over process of the both channels. Dependent on the setting of the SLOPE potentiometer there are the following volume curves:

Fig. 11.1: Volume curve I (SLOPE potentiometer completely left)

ENGLISH

Fig. 10.2: Headphones connector

10. Crossfader Adjustment

On the main motherboard you can find two potentiometers, which you can adjust with a little screwdriver. These potentiometers are identified as OVERLAP and SLOPE.

You can unscrew the bottom of your mixer to reach the main motherboard.

Please be aware that the BEHRINGER warranty becomes discretionary when you start disassembling your DX2000USB! Don’t even think of it, if you make much of your warranty privileges. Sorry, but we have to mention this.

10.1 Overlap

 

With the OVERLAP potentiometer (VR43) you can adjust the

 

increase or decrease in dB, which is conducted when the

 

crossfader is located in the middle position. Ex works this

 

value is adjusted at -3 dB and should not be modified. This

Fig. 11.2: Volume curve II (SLOPE potentiometer completely right)

guarantees a constant volume across the entire fader path.