
EUROLIVE E1220A/E1520A
1.1.2 Initial operation
Be sure that there is enough space around the unit for cooling. To avoid overheating, do not place the E1220A/E1520A on top of power amps or near radiators, etc.
++ Blown fuses must be replaced by fuses of the same type and rating. Please refer to the “SPECIFICATIONS” for further details.
The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all international safety certification requirements.
++ Please make sure that all equipment is properly grounded at all times. For your own safety, never remove or disable the ground conductor of the unit or of the AC power cord.
++ The sound quality may diminish within the range of powerful broadcasting stations and
Warning
++ This loudspeaker is capable of producing extreme vol- umes. Please keep in mind that high sound pressures do not only temporarily damage your sense of hearing, but can also cause permanent hearing damage. Be careful to select a suitable volume at all times.
1.1.3Online registration
Please remember to register your new BEHRINGER equipment right after your purchase by visiting www.behringer.com (alterna- tively www.behringer.de) and read the terms and conditions of our warranty carefully.
Should your BEHRINGER product malfunction, our goal is to have it repaired as quickly as possible. To arrange for warranty service, please contact the retailer from whom the equipment was purchased. Should your BEHRINGER dealer not be located in your vicinity, contact directly one of our subsidiaries. Corresponding contact information is included in the original equipment packaging (Global Contact Information/European Contact Information). Should your country not be listed, please contact the distributor nearest you. A list of distributors can be found in the support area of our website (www.behringer.com).
Registering your purchase and equipment with us helps us process your repair claims quicker and more efficiently.
Thank you for your cooperation!
2. Control elements and connections
Fig. 2.1: Control elements and connections (E1220A and
E1520A)
{1} Use this 1/4" stereo jack to connect a signal source that has 1/4" output.
{2} Use this XLR connector to connect a signal source that has XLR output.
++ Always use either the XLR or the 1/4" jack input, and use the LEVEL control {4} to adapt the input sensitivity.
Never use both inputs at the same time!
{3} The LINK OUTPUT is directly connected to the inputs of the E1220A/E1520A and carries the input signal with no processing applied. In this way, you can route the signal to the input of another device (for example, a second E1220A/E1520A).
{4} To set the volume of the LINE or MIC signal, use the LEVEL control. The left half of the control range is for attenuating the LINE signal. The right half is for raising the level of the MIC signal.
{5} The CLIP LED lights up when signal distortion occurs. Reduce the volume with the LEVEL control until the CLIP LED does not light up any more, or occasionally lights up at signal peaks.
++ We would like to draw your attention to the fact that extremely loud sound levels may damage your hearing as well as your headphones/loudspeakers. Turn the LEVEL control fully to the left before you switch on the unit. Be careful to select a suitable volume at all times.
{6} The HIGH control adjusts the level of the
{7} The PWR LED lights up when the loudspeaker is put into operation.
{8} The LOW control adjusts the level of the
Control elements and connections | 5 |