9EUROPOWER PMP2000 User Manual

¼" TS footswitch connector

strain relief clamp sleeve

tip

sleeve

pole 1/ground

tip pole 2

The footswitch connects both poles momentarily

Fig. 4.4: ¼" TS connector for footswitch

4.4 Loudspeaker connections

Your EUROPOWER is equipped with high-quality Neutrik Speakon-compatible loudspeaker connectors, which ensure safe and trouble-free operation.

The Speakon connector was especially developed for high-power loudspeakers.

Once it is plugged in, it safely locks into position and cannot be accidentally disengaged. It prevents the occurrence of electrical shock and ensures the correct polarity. Each of the connectors carries only the assigned single signal (see tab. 4.1/fig. 4.6 and the information on the rear panel of the power mixer).

Fig. 4.5: Loudspeaker connector

Please be sure to only use commercial Speakon cables (type NL4FC)

for connecting your loudspeakers to the PMP2000. Please check the pin assignment of your loudspeakers and cables dependent on the PMP2000 speaker output you choose.

 

1+

1-

2+

2-

RIGHT/MONO MAIN

POS

NEG

—

—

LEFT/MONITOR

POS

NEG

—

—

BRIDGE

POS

NEG

—

—

Tab. 4.1: Polarity configuration of speaker connectors

LEFT/MONITOR

RIGHT MONO MAIN

+1 +1

16 Ω

-1

-1

16 Ω

 

 

8 Ω

 

 

8 Ω

4 Ω

 

 

4 Ω

BRIDGE

 

 

 

+1

 

 

 

 

 

 

16 Ω

 

 

 

8 Ω

+2

 

 

 

Fig. 4.6: PMP2000 loudspeaker connector assignment

5. Wiring Examples

Loudspeaker connection (FOH mix)

PMP2000 rear panel (part view)

2 x BEHRINGER EUROLIVE

Stack (B1500 & B1020, both passive)

Loudspeaker connection (monitor mix)

PMP2000 front panel (part view)

Footswitch

2 x BEHRINGER B300 (active)

Fig. 5.1: PMP2000 as stereo amplifier (example)

◊Please set the MODE switch (21) to “LEFT/RIGHT” for this application

behringer.com