Behringer PMP1680S, PMP960M, PMP980S 5.Wiring Examples, Loudspeaker (F.O.H. mix), Loudspeaker connection (monitor mix), Loudspeaker connection for F.O.H and monitor mix (mono)

11EUROPOWER PMP1680S/PMP980S/PMP960M User Manual

5.Wiring Examples

For stereo operation the POWER AMP switch (28) of the PMP980S/PMP1680S must be set to its upper position (MAIN L/MAIN R). Outputs A and B deliver the stereo main signal to the P.A. speakers. Two active speakers, wired in parallel, are connected to the preamp monitor output. They are used as on-stage monitor speakers. The effects processors can be switched on and off with a dual footswitch. This set-up is not possible with the PMP960M (no stereo operation possible).

PMP1680S

2 x BEHRINGER EUROLIVE Stack (B1800X & B1220, both passive)

Loudspeaker (F.O.H. mix)

Dual footswitch

PMP1680S Front Panel (excerpt)

2 x BEHRINGER B215A (active)

Loudspeaker connection (monitor mix)

Fig. 5.1: EUROPOWER mixer as a stereo amplifier (example)

Both the PMP980S/PMP1680S and the PMP960M can be set-up for dual mono operations. The POWER AMP switch (28) must be set to its lower (PMP960M) or center position (PMP980S/PMP1680S). The two loudspeaker outputs provide the main and monitor signals independently of each other and to two loudspeakers each, which are wired in parallel.

PMP960M Rear Panel (excerpt)

2 x BEHRINGER EUROLIVE B1520	2 x BEHRINGER
(passive)	EUROLIVE F1520
	(passive)

Loudspeaker connection for F.O.H and monitor mix (mono)

Fig. 5.2: EUROPOWER as a dual mono amplifier (example)