
EUROPOWER PMH2000
4.INSTALLATION
4.1Mains voltage
Before connecting the PMH2000 to the mains, please carefully check that your equipment is set to the correct voltage! Blown fuses must be replaced by fuses of the same type and rating!
4.2 Mains connection
The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all of the international safety certification requirements.
+Please make sure that all units have a proper ground connection. For your own safety, never remove or disable the ground conductor from the unit or of the AC power cord.
4.3 Audio connections
The in and outputs of your BEHRINGER PMH2000 are de- signed as unbalanced 1/4" mono
+Please ensure that only qualified personnel install and operate the PMH2000. During installation and operation, the user must have sufficient electrical contact to earth. Electrostatic charges might affect the operation of the unit.
Fig. 4.1: 1/4" mono plug
Fig. 4.2: 1/4" stereo plug
Fig. 4.3: XLR connectors
Fig. 4.4: 1/4" TS connector for footswitch
4.4 Loudspeaker connections
Your EUROPOWER is equipped with
Fig. 4.5: Loudspeaker connector
Please be sure to only use commercial SPEAKON® cables (type NL4FC) for connecting your loudspeakers to the PMH2000. Please check the pin assignment of your loudspeakers and cables dependent on the PMH2000 speaker output you choose.
| 1+ | 1- | 2+ | 2- |
RIGHT/MONO MAIN | POS | NEG | - | - |
LEFT/MONITOR | POS | NEG | - | - |
BRIDGE | POS | NEG | - | - |
|
|
|
|
|
Tab. 4.1: Polarity configuration of speaker connectors
4. INSTALLATION | 7 |