10EURORACK PRO RX1602 User Manual
Balanced ¼" TRS connector
strain relief clamp
sleeve ring tip
sleeve ground/shield
ring cold
tip
hot (+ve)
For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug.
Fig. 4.2: 1/4" TRS connector
¼" TRS headphones connector
strain relief clamp
sleeve ring tip
sleeve ground/shield
ring
right signal
tip
left signal
Fig. 4.3: 1/4" TRS connector for headphones operation
5. AUX Channels Modification
All monitor and effects signals are tapped into post mute and pre fader,
which resembles the function of a pre fader aux channel on conventional mixing consoles. If you prefer to use the aux channels mainly for effect applications, we suggest to alter them to post Fader. The difference is that you extract
the respective channels’ signal from the effect mix, too, when you turn the
◊The following modifications put your soldering skills to the test. Only attempt to implement them if you feel you have enough past experience. Consider hiring professional help. Regardless of who implements these modifications, they effectively void all warranty claims.
◊A piece of advice for the brave: bridge endings that are to be soldered should not be put into the drill holes. Instead, bridge endings should be soldered above the drill holes in a flat fashion! A bridge should be somewhat upwardly curved between both of the bases.
1.Power down the unit and unplug the power cord before you remove the cover from the rest of the housing!
2.The positions in question are found on the part of the circuit board located perpendicular to the front side. Please observe figure 5.1.
◊Hold the unit so that you can read the FX/MON insignia on the circuit board. Soldering points should match those in the illustration.
3.Separate the “pre fader” conductor path.
4.Solder a “post fader” bridge.
5.Repeat this step on as many channels as desired.
cut “pre Fader”
add “post Fader” link
Fig. 5.1: Modification MON/FX “pre fader” > “post fader”0