Behringer T-1 2. Control Elements and Connections, 2.1 Microphone, 2.2 Power supply, Here you also find the following:, •a seven-pinXLR connector to connect to the T‑1 (MIC)

4TUBE CONDENSER MICROPHONE T-1 User Manual

2. Control Elements and Connections

2.1 Microphone

You can tell that the T‑1 is switched on when the small window glows red. It is also possible to activate an attenuation of −20 dB on the side of the T‑1, for example, when signal sources are very loud. There is an XLR connector on the bottom end of the microphone. Connect it to the power supply (PSU‑T).

2.2 Power supply

The included BEHRINGER PSU‑T not only provides the supply voltage for the tube preamplifier but also employs a circuit that reduces the low frequency response. This is activated on the front panel with the LOW CUT switch.

The POWER switch on the unit's rear panel turns on the power supply.

Here you also find the following:

•a seven-pin XLR connector to connect to the T‑1 (MIC),

•a three-pin XLR connector to transmit the signal (OUTPUT),

•a switch to suppress signal humming noise (GND LIFT),

•an IEC power receptacle

•and a fuse holder.

◊Use the provided cable to connect the T‑1 to the power supply unit!