ENGLISH
4
Note: The PHONO inputs only support moving magnet cartridges. These are the most common type, so unless you know your player uses a moving coil cartridge, assume that your system will work.
[5]Headphones output – Plug your headphones into the
PHONES output using a ⅛" mini plug.
[6]Headphones volume – Adjust the headphones volume with the adjacent control.[7]USB cable – Plug the USB cable into a free USB port on your computer.
[8]Power indicator – Upon connection, the UFO’s power indicator will light up and the computer should automati- cally recognize the connection.
Software Installation
•This device requires no special setup or drivers, just plug it into a free USB port on a PC or Mac computer.
•The UFO202 comes with a free version of Audacity editing software. This will help make the transfer process quick and simple. Simply insert the install CD into your
•For other audio needs, such as advanced editing, instru- ment recording, sequencing, etc., a free version of energyXT2 Compact BEHRINGER edition is also included.
Hookup Diagram
Ground |
|
|
|
| RCA Ins |
|
|
| ||||||
RCA Outputs | ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
| |||
Line/Phono |
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Computer 
USB
Headphone Out
Hooking up a record player
1.To transfer music from a record player, a special preamplifi- cation process must take place in order to boost the low signal level coming from the player. To do this, simply move the LINE/ PHONO switch on the UFO202 to the right (PHONO selected).
2.Connect a stereo RCA cable from the record player outputs to the RCA inputs on the UFO202. The player will also likely have
a ground cable that needs to be attached to the ground terminal on the UFO202.
3.Connect a monitoring device. You may plug speakers into the RCA outputs or connect a pair of headphones to the PHONES output.
4.Connect the attached USB cable to a free USB port on your computer.
RCA Ins
RCA Outputs
Line/Phono
Computer 
USB
Headphone Out
Hooking up a tape player
1.Move the LINE/PHONO switch on the UFO202 to the left (LINE selected).
2.Connect a stereo RCA cable from the tape player outputs to the RCA inputs on the UFO202.
3.Connect a monitoring device. You may plug speakers into the RCA outputs or connect a pair of headphones to the PHONES output.
4.Connect the attached USB cable to a free USB port on your computer.
Recording Process
•After hookups have been made and software installed, you are ready to record the audio. Make sure your audio recording program is set to record input from the USB port. For simple record, cut, and export of stereo audio, you may prefer to use Audacity. For more extensive editing, energyXT2 Compact may be the best choice
•If recording from a tape player, make sure the player's volume is turned up all the way.
•Adjust the input sensitivity of the recording program to achieve optimal sound quality. Too much signal will cause the recording to distort; too little signal will sound faint and thin, so record a test clip to ensure quality sound. The recording program should have meters that display the levels as the audio streams.