ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket. The appliance must be positioned so that the plug is accessible.

Should the mains lead of the appliance become damaged or should it need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BEKO Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

TRANSPORTATION INSTRUCTIONS

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.When positioning your appliance take care not to damage your flooring, kitchen furniture, related parts and doors, pipes, wall coverings etc. Do not move the appliance by pulling by the door.

6.Empty any water in the drain tray before moving. See section ‘Defrosting’ and ‘Care & cleaning’ for further information.

7.Make sure that the defrost water pipe at the back of the product is fixed to the

plastic evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.

IMPORTANT! FITTING A DIFFERENT PLUG As the colours of the wires in the

mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

(See diagram).

1.Connect the green-yellow or green (Earth) wire to the terminal in the plug marked 'E' or with

the symbol or coloured green and yellow or green.

2.Connect the blue (Neutral) wire to the terminal in the plug marked 'N' or coloured black.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GREEN &

 

 

 

 

 

 

6mm.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

YELLOW

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OR

32mm.

 

 

 

 

L

 

 

 

 

GREEN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BROWN

 

6mm.

 

 

 

 

 

 

 

 

 

 

 

N

 

 

 

 

 

 

OR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

22mm.

RED

 

 

 

 

BLUE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

12mm.

OR

 

 

6mm.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BLACK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CORD GRIP

FUSE

FITTED WITH BS 1362 13A FUSE ALWAYS FIT BS 1362 REPLACEMENT CARTRIDGE FUSE

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

"IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed.

IMPORTANT

INSTALLATION INSTRUCTIONS

1. The space in the room where the appliance is installed must not be smaller

than 10 cubic metres.

2. See pages 16 to 23 for detailed Installation Instructions including reversing

door opening direction.

3.Connect the brown (Live) wire to the terminal in the plug marked 'L' or coloured red.

With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or

in the main fuse box.3 If in doubt contact a qualified electrician.

3. Do not put your fridge freezer in a cold room where the temperature is likely

to go below +5 degrees C (41 degrees F) during night time and/or especially

in winter.

4

Page 2 Page 4
Page 3
Image 3
Beko BC50F manual Electrical Requirements, Installation Instructions
Page 2 Page 4

BC50F specifications

The Beko BC50F is an outstanding addition to any home, designed to offer both functionality and efficiency. This freezer model exemplifies modern engineering, providing optimal storage solutions for a variety of food items while maintaining energy efficiency.

One of the most notable features of the Beko BC50F is its generous storage capacity. With a substantial volume, this freezer allows users to store a wide array of frozen goods, making it ideal for families or anyone looking to stock up on groceries. The interior is designed with adjustable shelves and compartments, enabling users to customize their storage space according to their needs. This flexibility is complemented by transparent drawers, which provide easy visibility of contents, ensuring nothing gets lost or forgotten at the back.

The Beko BC50F also boasts advanced freezing technology. One of its key features is the Fast Freeze function, which rapidly freezes food right after purchase, preserving its nutrients and flavor. This is particularly useful when freezing fresh produce or meals, ensuring the highest quality for later use. Additionally, the freezer operates efficiently with a low-noise level, allowing it to fit seamlessly into any kitchen without creating disturbances.

Energy efficiency is another hallmark of the Beko BC50F. It is designed to operate within an energy-efficient framework, contributing to lower energy bills while reducing the environmental impact. The appliance is rated in line with high energy class standards, which reflects its ability to perform optimally without consuming unnecessary electricity.

Another significant characteristic is the frost-free technology, which eliminates the hassle of manual defrosting. This feature ensures that ice build-up is minimized, maintaining the freezer’s efficiency and saving the user time and effort.

The Beko BC50F is also designed with user convenience in mind. It includes a reversible door feature, allowing for flexible installation in various kitchen layouts. Furthermore, the sleek and modern design adds an attractive aesthetic to any kitchen space.

In summary, the Beko BC50F combines ample storage capacity, advanced freezing technologies, energy efficiency, and user-friendly features, making it a smart choice for anyone seeking a reliable and aesthetically pleasing freezer solution.
Top Page Image Contents