TRANSPORTATION INSTRUCTIONS
1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.
2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.
3.Failure to comply with the above instructions could result in damage occuring
to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
5.Empty any water in the drain tray before moving see section “Defrosting” and “Cleaning & Care” for further information.
IMPORTANT : Make sure the plastic evaporating pan at the back of the product collects water properly.
IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.
Important : This appliance is not designed for stacking with any other appliance.
When positioning your appliance, take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.
Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.
"IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."
Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed.
IMPORTANT
INSTALLATION INSTRUCTIONS
1.To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions.
2.Do not operate this applliance unlees installed to furniture.
3.The appliance should be located on a smooth surface. The four front and back feet can be adjusted as required. To ensure that, your appliance is standing upright adjust the four front and back feet by turning clockwise or
4.Refer to "Cleaning and Care" section to prepare your appliance for use.
5.This appliance has been designed to operate in ambient temperatures between +10 and +32 degrees C (50 and 90 degrees F). There fore if the appliance is installed in an unheated / cold room (E.g.: Conservatory /annex / shed / garage etc.) then the appliance may not operate and as a result the storage time of food may be reduced.
10 mm |
To avoid any loss in performance, air suction channels should not be obstructed. (140 cm2) Minimum distance between the wall and the appliance must be at least 10 mm.
40 mm | 10 mm | 40 mm |
|
Wall
Appliance
4 | 5 |
|
