Beko DP 8045 CW manual Do not reach into the machine when the drum is spinning

clearly suggested in the operating instructions or the published service manual. Otherwise, you will be putting your life and others' lives in danger.

•For failures that you cannot remedy by applying the procedures in safety instructions, turn off and unplug the product and call the Authorised Service Agent.

•Do not reach into the machine when the drum is spinning.

•Do not use extension cords, multi- plugs or adaptors to connect the dryer to power supply in order to decrease the risk of fire and electric shock.

•Never wash the product by spreading or pouring water onto it! There is the risk of electric shock!

The final step of the drying programme, namely the cool-down step is performed without applying heat to ensure that the laundry items are kept at a temperature that will not damage them. If you open the loading door before the cool-down step completes, hot vapour will come out.

ANever stop the dryer before the programme completes. If you must do this, remove all laundry quickly and lay them out to a suitable place to dissipate the heat.

•Always clean the lint filter before or after each loading. Never operate the dryer without the lint filter installed.

•Clean ventilation grid of the product regularly. Do not allow fibre, dust and dirt accumulation around the ventilation grid and at adjacent areas.

•Power cable plug must be within easy reach after installation.

•Do not dry unwashed items in the dryer.

7

•Items soiled with cooking oils, acetone, alcohol, fuel oil, kerosene, stain removers, turpentine, paraffin and paraffin removers must be washed in hot water with plenty of detergent before being dried in the dryer.

•Garments or pillows bolstered with rubber foam (latex foam), bathing caps, water resistant textiles, materials with rubber reinforcement and rubber foam pads should not be dried in the dryer.

•Do not use fabric softeners and anti-static products unless they are recommended by the manufacturers of the relevant product.

•Use softeners, anti-static products and etc. in accordance with the instructions of their manufacturers.

•Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product.

•Do not install or leave the dryer in places where it will be exposed to outdoor conditions.

•Your product can be operated at temperatures between +5°C and +35°C. If the operating conditions fall outside of this range, operation of the product will be adversely affected and it can get damaged.

•Do not tamper with the controls.

•Unplug the product when it is not in use.

•Remove the loading door of the drying compartment before decommissioning or disposing of the product.

•Check all garments before loading and make sure that there is no any lighters, coins, metal pieces, needles, and etc. in their pockets or on them.

•Make sure that the pets do not enter

EN