Beko GNE V322 X manual Prior to first use of Ice/Water Dispenser

Models: GNE V322 X

1 34
Download 34 pages 6.43 Kb
Page 18
Image 18
Prior to first use of Ice/Water Dispenser

Prior to first use of Ice/Water Dispenser

C Water mains pressure must not be below 1 bar.

C Water mains pressure must not be over 8 bars.

C Pumps must be used in case the supply water pressure drops below 1 bar or if a bottle is going to be used.

C Water system of the refrigerator must be connected to the cold water line. It must not be connected to hot water line.

C No water may be obtained in the initial startup of the refrigerator. This is caused by the air in the system. To discharge air from the system, press Dispenser latch for periods of 1 minute until water comes from the Dispenser. Water flow may be irregular in the beginning. Irregular water flow will be normalized after the air in the system is discharged.

C At the initial startup of the refrigerator approx.12 hours must pass before cold water can be obtained.

C Water mains pressure must be between 1-8 bars for the operation of Ice/Water Dispenser smoothly. For this, check that 1 glass of water (100 cc) can be filled in 10 seconds.

C The first 10 glasses of water should not be consumed.

C 12 hours must pass to obtain ice from the Ice Dispenser for the first time. If there is not enough ice in the ice dispenser, ice may not be obtained from ice dispenser.

C Approximately the first 30 cubes of ice to be obtained from the Ice Dispenser must not be used.

C Always use the water filter when a bottle is not being used.

17

EN

Page 18
Image 18
Beko GNE V322 X manual Prior to first use of Ice/Water Dispenser