Rear Panel Connections
REF1000 Rear Panel
Never Connect Either the Positive or Negative Speaker Output to Any Ground Contact!
Connecting any Speaker Output on the REF1000 to Ground will cause the amplifi- er to go into protection and could damage the amplifier and void the warranty.
1)Power Switch: Power is on when the switch is toggled to the I position and off in the O position.
2)Input Connections and RCA/XLR switch: When using RCA cables for the input insure that the RCA/XLR switch is pressed in to the RCA posi- tion. When using XLR cables insure that the switch is out in the XLR position. This will generally insure ideal grounding and minimize ground noise from interfering with the audio signal.
3)Output Connections: Attach your loudspeaker to the output connec- tors, insure that the polarity of each speaker is correct and the same so
that no phase inversion can occur.
Never Connect Either the Positive or Negative Speaker Output to Any Ground Contact!
4)IEC power cord jack: Connect a heavy gauge power cord from this jack to the wall power supply. Note the power setting indicated on the back of the amplifier before connecting the power.
When all connections to and from the amplifier have been made then double check everything, insure that the pre- amplifier is powered on and set to a Mute setting and power on the REF1000.
© 2005 bel canto design, Ltd. | page 6 | REF1000 | User’s Guide 1105 | Rev.A |
|
|
