Belkin RemoteTV 5GHz Wireless TV Adapter user manual Installation

Installation

Follow the steps below to begin using the PureAV RemoteTV.

1.Connect your audio and video cables to the appropriate ports of the PureAV RemoteTV Transmitter (the Transmitter) and the PureAV RemoteTV Receiver (the Receiver) as illustrated in the previous pages.

2.Plug the IR adapter into the IR port located on the rear panel of the Transmitter and place the head near the IR port of the source device as illustrated in the previous pages (TV, DVD player, VCR, etc.) (This allows you to control the functions of the source device through the Receiver using the source device’s remote control).

3.Plug in the power supplies of both the Transmitter and Receiver, and then turn each unit on.

4.Check the status LEDs on the Transmitter and Receiver. If the LINK LED on both the Transmitter and Receiver are green, the wireless connection has been established and the setup procedures are complete.

��������������

���������������������������

������ ������������

����	���������������	�������������
	�����	���������
	���	���������
�����		����������������������
		����������������������
������
		��������������������
		����������������

5.Turn on the source device (DVD player, VCR, etc.) Turn on the remote device (TV or other display).

6.Each time the Receiver is turned on, it will default to composite-video mode. If you are using s-video or component video cables, press the “Video Source” button to cycle through the available video modes (composite, component, or s-video).

Note: Be sure that you are aware which set of AV inputs you used when connecting the Receiver to the TV or other display. (Most TVs and video displays are equipped with multiple audio video inputs, i.e., AV1, AV2, etc.) It will be necessary to select the same AV input mode using your display’s remote control. Refer to your display’s user manual to configure this setting.

PureAV RemoteTV

12