Technical Bulletin
Bulletin No: | Effective Date: | Cancels: Same dated | Page: 1 of 2 |
Subject: Cyclone DuraDrain™ Trailer Water Separator
In addition to the service information presented in the Cyclone DuraDrain™ trailer water separator Service Data Sheet
CYCLONE DURADRAIN™SERVICE INTERVALS
Service intervals are dependent on specific environmental and operational factors that control the amount of contamination removed by the Cyclone DuraDrain™ unit. Experience should be used to determine how frequently the unit must be serviced. As a recommended minimum, every 12 months, 100,000 miles or 3,600 operating hours, perform the Operational and Leakage Tests. As indicated in the Service Data Sheet, inspect the Cyclone DuraDrain™ unit for unrestricted airflow and blockage from debris collection. Remove the purge nut and service according to the “Disassembly and Cleaning” instructions.
CYCLONE DURADRAIN™ TRAILER WATER SEPARATOR AIR LEAKAGE TROUBLESHOOTING
This is the recommended troubleshooting procedure should an audible air leak be detected from the Cyclone DuraDrain™ trailer water separator. Be sure to review and follow all safety guidelines in the Service Data Sheet before servicing the DuraDrain™ trailer water separator.
DO NOT DISCONNECT OR REMOVE THE CYCLONE DURADRAIN™ BODY.
All servicing can be done without disconnecting the air lines and without removing the Cyclone DuraDrain™ trailer water separator body. All servicing is done to the removable hex purge nut located on the bottom. See the illustration below.
Cyclone DuraDrain™ trailer water separator
Hex Purge Nut
© 2006 Bendix Commercial Vehicle Systems LLC All rights reserved. 3/2006 Printed in U.S.A.
