Connecting equipment to the Component Video input | BenQ PB2250

Connecting equipment to the Component Video input

S-Video	Video
USB	Audio	D-Sub

Component Video Cable (optional accessory)

RGBYPbPr

AV equipment

The projector is capable of displaying various High Definition TV display modes. Some of these sources are:

•	Digital-VHS (D-VHS) player	•	DVD player
•	Satellite Dish HDTV receiver	•	Digital TV tuners

Most of these sources will provide an analog component video output, either a standard VGA (D-sub) output, or a YPbPr (default) format.

The projector is capable of accepting digital TV data through a Component Video connector. Use a Component Video cable (optional accessory) to display these images.

The following standards are supported in the digital TV function:

•	480i	•	480p
•	576i	•	576p
•	720p (50/ 60 Hz)	•	1080i (50/ 60 Hz)

Connecting Video and S-Video devices

S-Video devices

S-Video	Video
USB	D-Sub

S-Video cable

Audio cable

Connection 15

Image 19

BenQ PB2250 user manual Connecting equipment to the Component Video input, Connecting Video and S-Video devices

Contents

Welcome Disclaimer Copyright Table of Contents Iv Table of Contents Temperature informationSupported timing for Component-YPbPr Input But could fail if power cuts or surges Important safety instructionsImportant safety instructions Safety instructions Bedding or any other soft surface Locations near fire alarmsLocations with an ambient temperature Using the unit when it is not fully Safety instructions Introduction Projector featuresIntroduction Shipping contents Bottom side Projector exterior viewFront / Upper side Rear side External control panel Controls and functions Functions Descriptions Remote control description Installing or replacing the remote control battery Remote control effective range Choosing a location Positioning your projector Focus ring Zoom ring Obtaining a preferred projected image size Screen size chart 169 aspect ratio Screen size chart 43 aspect ratio Connection Connecting to a laptop or desktop computerConnection Video cable Audio cable Connection Connecting equipment to the Component Video inputConnecting Video and S-Video devices Video devices Video devices Video cable Start up Utilizing the password functionSwitch all of the connected equipment on Operation If you forget the password Fine-tuning the image size and clarity Adjusting the imageAdjusting the height Auto-adjusting the image Correcting keystone On the remote control Hiding the image Switching input signalsShutdown Menu system Menu operation Using the menus Picture menu Pro-Picture menu Setting menu Advance menu Lamp Hour ResolutionInformation Menu Source Care of the projector Maintenance Replacing the lamp Lamp informationMessage Status Do not turn the power on with the lamp cover removed Stand-by mode Temperature informationIndicators Light Status & Description Power Temp Lamp Power events Thermal events Lamp events Optional accessories not included in the standard package Service informationAccessories included in the standard package Alternative accessories vary by regions Cause Remedy TroubleshootingPlug the power cord into the AC inlet on Make sure that it is switched on Projector specifications Specifications Dimensions Supported timing for Video and S-Video inputs Timing chartSupported timing for PC input Supported timing for Component-YPbPrInput Limited warranty WarrantyWarranty MIC statement Regulation statementsFCC statement EEC statement