INSTALL FILTERS
DUCTED CONFIGURATION ONLY
1.To remove the GREASE filter, grip the latch tab and pull it down. This will disengage the filter from the hood. Tilt the filter down- ward and remove.
2.To install the GREASE filter, align rear filter tabs with slots in the hood. Pull latch tab down, push filter into position and release. Make sure the filter is securely engaged after assembly.
DUCTFREE FILTER
INSTALLATION
NON DUCTED CONFIGURATION ONLY
1.Purchase a ductfree filter kit (model no. FILTERK3490CM or FILTERK3448) from your dealer.
2.Remove the grease filters by pushing them back to compress the retaining springs, then tilt filters down and out of front groove.
3.Holding the ductfree filter on its side, insert one of the support rods, (supplied with fil- ters) into the upper groove in back that runs parallel with the front of the hood, in order to avoid that the filter might be sucked onto the motor.
4.Fold the filter and insert it into the front.
GREASE
FILTERS
GROOVES
DUCTFREE
FILTERSUPPORT
ROD
SUPPORT
ROD
- 12 -