Billy Goat 350397 manual POWER RAKE SEEDER BOX KIT-350395AND, Replacing Slicing Reel

POWER RAKE SEEDER BOX KIT-350395 AND 350397

REPLACING SLICING REEL

To replace the current reel with a slicing reel it will take approx. 20 min. and requires 1/2" and 9/16" sockets, and a ratchet with extension. Use these instructions in conjunction with your owner’s manual to identify all parts mentioned.

1.Wait for engine to cool and disconnect spark plug.

2.Close fuel valve on engine (if available)

3.Lean unit back onto lower handles and secure in place.

4.Remove (7) lock nuts (item 62 & 40) holding the belt and shaft

guards (item 21 & 22) in place. It is necessary to lower the height adjust lever to reach the locknuts on the guards. Remove the guards.

5. Remove the drive belt (item 9) by "walking" it out of the groove on the reel pulley (item 2).

6. Remove the (4) lock nuts (item 60) and washers (item 68) holding the bearings (item 23) to the frame of the unit.

7. The reel is now free from the machine. Slide the reel down and out of the machine.

8.Assemble reel fig.2. After assembly reattach items in fig.1 in

the sequence shown. The shield bearing (item 30), pillow block bearing (23), spacer (10), pulley (2), washers (68), nuts (60) can be reused if they are not damaged. The lock washer twisted tooth p/n 400502 (57), screwcap reel pulley p/n 8041050 (71), and key 3/16” x 1” p/n 9201078 (42) must be replaced. Note: pulley, key and spacer must be inserted only onto the side of the reel that will be driven by the engine. The angled edge of the blades should be facing the direction in fig. 1 to dig into the ground otherwise the machine will not perform the proper function. See rotation arrow.

9. Replace with fully assembled slicing reel.

10.Re-install the reel in reverse order of removal. Re-install the guards in reverse order of removal. Tighten all hardware securely.

11.Rotate the reel to make sure of even rotation.

12. Reattach spark plug and open fuel valve, if excessive		Fig. 1
vibration occurs cease action immediately and check belt and
reel alignment and all hardware that might be loose.
	item	PARTS	PR500	QTY
	no.	LIST	Part No.
	57	LOCK WASHER 5/16 TWISTED TOOTH	800177	1
	71	SCREWCAP 5/16 - 24 x 1" HCS GR. 5	400164	1
	80	SHAFT SLICING WA	350142	1
	81	BLADE SLICING REEL	350147	20
	82	PLATE BLADE MTG.	350148	20
	83	SPACER BLADE MTG.	350149	10
	84	SPACER BLADE ASSY	350150	9
	85	SCREWCAP 1/4-20 x 3/4, HCS ZP	8041004	40
	86	NUT LOCK 1/4-20	8142004	40
	87	COLLAR SPACER	350152	1
	88	WASHER 0.937 x 1.750 x 0.119	350153	1
	89	WASHER LOCK 7/8 INT. TOOTH	350154	1
	90	NUT JAM 7/8-14	350155	1
Fig. 2
Part No 350398	- 4 -	Form No F102207B