Billy Goat EX17D50012 owner manual Assembly, Figure A, Figure B

FORCE 6 BLOWER Owner’s Manual

ASSEMBLY

1.Follow the steps in figures A and B, then securely tighten all hardware shown. 2.Connect spark plug wire.

Figure A Figure B

The hardware for attaching the upper handle to the lower can be found on the lower handle. Install upper handle (item 24), to preassembled lower handles (item 25 & 26) by sliding the upper over and down the inside of the lower handle. Using bolt (item #12), washers (item #10) & lock nut (item #11) to install upper handle to lower handle. Finish installing the other side of the upper handle assembly using screw and lock nut provided. The Aim- and-Shoot TM is not attached, you will need to unroll the cable and attach the ball end to the lever and seat the cable end into the hole on the saddle clamp, with the cable running through the slot. To keep the cable from being damaged use three ty-wraps (item 61) to secure it to the handle, as shown making sure that the cable is not rubbing against the tire.

Attach the front tire using the hardware located on the front wheel bracket. Use a block to raise the front end of the unit off the ground. Insert the wheel spacer (item 17) into the wheel and place in between the bracket. Finally insert the bolt (item 20) through the bracket, wheel, and spacer and secure with the nut (item 27)

Two ½” open ended wrenches

Part No 441161

Two 9/16” Wrenches

9 Form No F042808A