SAFETY PRECAUTIONS
Like all mechanical tools, reasonable care must be used when operating the machine. Read all instructions!
1.Disconnect spark plug wire before servicing
2.Do not put gas in tank when hot or in an enclosed area.
3.Do not start engine or operate with bag or guards removed.
4.Keeps hands and feet clear of ALL inlet and discharge openings.
5.Do not operate with hose cap, bag, or hose removed.
6.Do not operate during excessive vibration!
7.Follow engine manufacturer operating and maintenance instructions.
8.Inspect machine and work area before starting unit.
9.Installation of debris bag- Make sure strap is tight and well secured.
10.Be sure zipper is closed before starting engine.
ASSEMBLY
Your Billy Goat is shipped from the factory in one carton, completely assembled except for the debris bag, and wheels. On models KD50C and KD55CKW the handle must be assembled.
1.READ operator’s instructions. Assemble wheels and handle securely in place. Do not over tighten.
2.UNFOLD the debris bag 1 and place mouth of bag over debris deflector and onto discharge outlet. Close zipper before starting engine.
3.TIGHTEN STRAP SECURELY to hold bag on dis- charge outlet.
4.ATTACH upper bag hanger straps by sliding grommet over rubber stud and on upper handle after handle is locked in place.
DUST IS THE GREATEST CAUSE OF LOST VACUUM! SHAKE BAG WELL AFTER EACH EMPTYING. RUN EN- GINE AT HALF THROTTLE FOR FIRST HALF HOUR TO CONDITION NEW
MAINTENANCE
1.ENGINE: See engine manufacturer instructions.
2.Inspect machine before starting unit.
3.Maximum vacuum: Maintain by emptying bag before it fills completely. Dust will block pores of bag and reduce vacuum. Stop motion and shake bag down without removing or stop machine and remove bag to shake free of dust. You may wash felt bags.
REPLACE SPARK PLUG WIRE, GUARDS, BAG, CAPS AND/OR HOSE BEFORE STARTING ENGINE.
PUT OIL IN ENGINE BEFORE OPERATION!
OPERATION
ENGINE: Must have gasoline and oil. See engine manufacturer operating instructions for type and amount. Engine must be level when checking and filling oil and gasoline. Never operate without aircleaner.
SPEED: Controlled by throttle lever on right side of handle, on model KD50C the throttle lever is on the engine with the stop switch. Under normal conditions operate at minimum throttle to accomplish your current cleaning task.
BAG: Do not place on or near hot surface.
VACUUM NOZZLE HEIGHT: This is raised and lowered by lifting slightly up on handle and pulling top left control. On models KD50C and KD55CKW pull lever 55.
PART NO. 900183 | FORM NO. 122887 |
