QL2300 Owner’s Manual
MOUNTING: Main unit | Typical on |
both sides | |
|
|
GENERAL: Unit must be securely mounted to a trailer, truck bed, or other similar surface before use. Do not use this unit in a freestanding position. Unit is not stable until it has been secured in place.
Secure unit by bolting through the base of the unit and through the
mounting surface using 3/8" dia. bolts, with washers and lockingFig. 1 nuts (see fig. 1)
MOUNTING: Unit can be mounted in various positions. Figure 2 illustrates the mounting options available when using the optional trailer (Billy Goat Part no. 790112) available from your Billy Goat dealer. The unit can be mounted to allow vacuuming from either side as well as from the rear.
MOUNTING: Exhaust elbow
1) Remove the loose hardware from the clamp assembly so that
there are 4 separate pieces (remaining clamp assembly, two halfFig. 2 plates, and a plate split).
2) Slide the assembled plates over the housing flange. The flange should rest between the bottom plate and the plate split.
3) | Slide the elbow over the plate spacer and center it in the clamp. |
|
| Step 1&2 |
| ||
The elbow flange should now be resting on the housing flange |
|
|
|
|
| ||
Housing | |||||||
between the plate split and the top plate. | |||||||
|
|
|
|
| |||
4) | Insert the other plate split beneath the plate spacer so the holes |
|
|
|
|
| |
align and the plate overlaps the flange on the elbow. |
|
|
| Elbow | |||
|
|
|
| ||||
5) | Secure the assembly with a plate half on top of the elbow |
| Step 3 |
|
| ||
flange and a plate half on bottom of the housing flange using 3, 1" |
|
|
|
|
| ||
|
|
|
|
| |||
carriage bolts and 3 lock nuts (removed hardware in step 1). |
|
|
|
|
|
6)Tighten down the clamp with 2, 1 3/4" carriage bolts, 2 knobs, and 2 lock nuts (removed hardware in step 1).
Step 4
Fig. 5&6
Part No 790294 | 10 | Form No F062906A |