Operation

Cleaning with your Auto Care

1. Hold the tool approximately 1” above the soiled surface. Press the spray trigger to apply the cleaning solution to the soiled area.

2. Using the brush on the tool, gently scrub the area to be cleaned.

3. For thorough cleaning, spray additional solution while the brush and suction are in contact with the surface.

4. Apply downward pressure on the tool and pull it toward you. The suction will remove the dirt and cleaning solution. Continue until no more dirt can be removed.

5. As a final step, use “drying strokes” (by not pressing the spray trigger) to remove as much liquid/moisture as possible. Repeat this step as often as necessary.

Maintenance and care

After cleaning

1.Unplug power cord from outlet.

Note: If a significant amount of Little Green formula/water remains, it is all right to leave it in the clean/solution tank for your next cleaning task.

2.Empty and rinse the dirty/collection tank after each use, OR when dirty water reaches the indicated maximum fill line. To remove the tank, lift up the dirty/collection tank release latch and remove the tank from the unit.

3.Disconnect the cleaning tool from the spray trigger by pushing down on button lock and pulling straight off.

(Do NOT twist tool to remove it)

4.Once removed from the spray trigger, clean tool by rinsing under running water.

5.Check spray nozzle for accumulated dirt or debris. If necessary, clean with soft bristle brush.

Machine storage

1.Wipe all surfaces with a soft cloth.

2.Wrap power cord around the cord wrap on the back of the Auto Care.

3.Wrap vacuum flex hose around the base of the unit and secure the spray trigger.

4.Store unit in protected, dry area, at room temperature (40º to 110ºF).

IMPORTANT:

Check the manufacturer’s tag before cleaning upholstery. “W” or “WS” on the tag means you can use your Auto Care. If tag is coded with an “S” (with diagonal strike-through), or says “Dry Clean Only,” do not proceed. If manufacturer’s tag is missing or not coded, check with your furniture dealer.

Tip:

 

Tip:

Deep cleaning

 

Check upholstery

stairs and

 

stuffing before

high-traffic

 

cleaning. Colored

areas on a

 

stuffing may

regular basis

 

bleed through

can prolong

 

the fabric when it

carpet life.

 

becomes wet.

 

 

 

Tip:

Before turning off the Auto Care, vacuum up clean water to thoroughly rinse out the interior of the vacuum flex hose. Then, lift the cleaning tool and point it upwards to drain any remaining water into the dirty/ collection tank.

Tank Release

Latch

WARNING:

Keep spray away from face. Failure to do so may result in personal injury.

16 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

Page 6
Image 6
Bissell 1425 warranty Maintenance and care, Cleaning with your Auto Care, After cleaning, Machine storage