10 www.bissell.com 800.237.7691
Operation
Set ready tools dial
Set ready tools dial to floor cleaning.
Power switch
1. Plug into a proper outlet and turn the power
and heater switches to the ON ( I ) position.
The switches are found on the back of the
handle. Allow 1 minute for the built-in heater
to warm-up before cleaning. The ProHeat
will be fully warmed and will provide optimal
performance after a minute of continuous
heated cleaning.
2. The SmartTemp ready light indicates when
the heater is ON ( I ).
Note: SmartTemp heats the cleaning solution
for carpet and hard floor application only. It
does not heat solution sprayed through the
accessory tools.
Cleaning strokes
1. While pressing the trigger, make one slow
forward wet pass and another one back. Let
the built-in heater, formula, and DirtLifter
PowerBrush do the work for you. Caution: Do
not overwet. Take care not to run over loose
objects, edges of area rugs, or the cord. Stalling
brush may result in premature belt failure.
2. Release the trigger and make one slow forward
and backward pass over the same area to
remove any residual dirty water, and aid in
drying. Repeat cleaning passes until solution
being pulled up appears clean. Continue passes
without pressing the trigger until you can’t see
any more water being pulled up.
NOTE: Both the SmartMix tank and the
clean water tank must have liquid in them
in order for the machine to spray. If one
tank is empty the machine will not apply
cleaning solution or water.
3. After cleaning, you may want to turn the
SmartMix dial to water rinse to give your
carpeting a final water only rinse. This will
ensure thorough removal of embedded dirt
loosened by the deep cleaning formula.
BISSELL deep cleaning formulas contain an
anti-resoiling agent that helps your carpets
repel dirt and keeps them looking good longer.
TOOLS
PRETREAT
FLOOR
CLEANING
ReadyTools Dial
Tip:Deep Cleaning stairs and heavy traffic areas
on a regular basis can prolong carpet life.
ON
OFF
SmartTemp Light
ON
OFF
Power Switch
SmartTemp Switch
WARNING: To reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
1.
2.
ug310-5941_7901bi_608.indd 10 6/24/08 1:39:02 PM