8 www.bissell.com 800.237.7691

Tank-in-Tank™

Our Tank-in-Tank system is designed with a heavy
duty bladder inside for clean water. As you clean,
the clean water in the bladder will empty and mix
with the cleaning formula. Dirty water pulled out of
your carpets will collect around the outside of the
bladder so that clean and dirty water are always
kept separate. This allows you to maximize tank
space, yet only carry one tank to and from the sink
for emptying and filling.

ReadyTools Dial

This provides either floor cleaning or above the floor
cleaning with the flip of a switch. If choosing above floor
cleaning for upholstery, stairs, or along the baseboards,
choose the attachment appropriate for the job. Attach
tool to the hose, and you are ready to go!

Flow Indicator

This is located on the machine base. It spins when
the trigger is pressed to indicate that the machine
is applying cleaning solution to the carpet and will
stop spinning when the SmartMix tank or bladder
needs to be refilled, or when the trigger is released.
Note: Flow Indicator does not spin when
spraying through the attachment hose.

Before you clean

1. Plan activities to give your carpet time to dry.
2. Move furniture to another area if cleaning an
entire room (optional).
3. Thoroughly vacuum area with a dry vacuum
cleaner before deep cleaning.
4. Plan your cleaning route to leave an exit path. It is best
to begin cleaning in the corner farthest from your exit.
5. Pretreating (optional)
Note: Pretreating is recommended to improve
cleaning effectiveness for heavily soiled carpet in
high traffic areas such as entryways and hallways.
A. Spray the BISSELL Tough Stain Pre-treat formula
onto heavy traffic areas, soiled areas, or stains.
B. Allow to penetrate for at least 3 minutes.
C. Following the instructions below, clean as
normal, using the BISSELL ProHeat machine
on the high traffic setting.
Special features of your BISSELL ProHeat
TOOLS
PRETREAT
FLOOR
CLEANING
ON
OFF
Flow Indicator
TOOLS
PRETREAT
FLOOR
CLEANING
ReadyTools Dial
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum or
deep cleaner may aggravate this
condition. Please see cleaning
fluid section on page 15.
1
START
HERE
4’
2
3
4
8
7
6
5
9
10
11
12
EXIT
3’
Operation
ug310-5941_7901bi_608.indd 8 6/24/08 1:38:59 PM