Bissell 1715 warranty When You’re Done Continued, Putting It Away, Battery Removal And Disposal

Fill Collection Tank with clean water. Rinse thoroughly and discard water. Be sure to rinse nozzle area.

Replace Plug and turn approximately 1/4 turn clockwise, until snug.

When You’re Done Continued

Remove the Tank Plug by turning approximately 1/4 turn

5. counterclockwise and lifting out. Empty Tank.

5.

6.

7.

To replace the Tank, engage hinge at bottom and tilt Tank

8. up to Handle, making sure that the Cleaning Solution con- nection in the Handle enters the port in the Tank. Depress the Tank Release Button, and snap the Tank into place. Test for a secure fit before using.

Check the Solution Tank. If a significant amount of BISSELL

9. Little Green formula/water remains, you may leave it in the Solution Tank for your next cleaning task.

Check Spray Nozzle for accumulated dirt or debris. If nec-

10. essary, clean with soft bristle brush.

11. Recharge Spot Lifter.

FULL

Putting It Away

Clean exterior surfaces of Spot Lifter with a soft cloth

1. dampened with water only. Do not use a strong detergent

or other cleaners, as this may damage the finish.

Store Spot Lifter in a protected, dry area, at room tempera-

2. ture (40° - 110°F).

Battery Removal And Disposal

WARNING:

This product contains a rechargeable nickelcadmium battery (sometimes referred to as a “Ni-Cad” battery) pack. The average life of a Ni-Cad battery is 5-7 years, depending on frequency of

1.

2.

Important: Unplug charger.

Remove tanks (front and rear) and discard.

Remove screws (6) holding Product Housing together

use. According to Federal regulations, proper removal and disposal of Ni-Cad batteries are required.

3. (see diagram).

4.

Use screwdriver to score Rating Label on bottom of unit.

Separate Housings and locate Battery Pack in bottom/ cen-

FULL

5. tre of unit.